Sunflower series of solar panel assembly racking contains HDPE cavity,front supporting legs,rear supporting legs,special HDPE bolts and nuts,clamps.It is called Sunflowers series solar panels mounting system.It can applied to concrete cement flat roof and even ground.Adopting this mounting system is more reliable and convenient,saving more labor charge and assembly tools are very simple.HDPE materials are high density polyethylene.It is food grade material which is full friendly to manhood,and has harmony to environment.
Working principle
- The HDPE cavity is in an empty state during installation, and it is relatively light in weight, which makes it convenient for transportation and installation.
- After the installation is completed, water or sand should be injected into the cavity to increase the overall weight, enabling it to resist wind loads and other external forces.
- When it is necessary to relocate or dismantle, water or sand can be drained out to restore the cavity to its lightweight state, facilitating transportation and reuse.
A.Assembly accessories: Mainly include HDPE nuts, M8 bolts and accessories, connecting pieces, clamping blocks, etc.
Installation guide
A.Assembly accessories: Mainly include HDPE nuts, M8 bolts and accessories, connecting pieces, clamping blocks, etc.
B.Place the counterweight foundation at the designated installation location and support it before installing the photovoltaic modules.
C.After installation, it will be as shown in the following figure:
D.After installation, it will be as shown in the following figure:
E.Two front supports and two rear supports have been installed as shown in the following figure:
F.Inflate, increase the weight of the load.
G.Connect the counterweight base by using the counterweight base connection piece to form a matrix.
Product Specification
|
Raw material |
Made of modified anti-aging HDPE material in line with Hunt water absorption test |
|
Wall thickness |
2 ~4mm(adjustable) |
|
Dimension(mm) |
Models:1180x1260x140mm Model E:1100X950 X130mm |
|
Counterweight(water filled ) |
Model s: 160kg min Model E: 120kg min |
Strategic Partners with Foner Solar
120 customers from more than 10 countries in the past 3 years.
Hot Tags: solar panel mounting on the roof, Water-based solar,Floating PV supplier,floating solar system, flat roof solar panel installation, Flat Roof Pv Mounting Systems, flat roof solar panel mounting, Installing Solar Panels On Flat Roof, Solar Panel Brackets for Flat Roof, Ballast Solar Panel Mounting with Water Filling