Application Scenario

The production process of the floating body for the floating solar mounting system

May 28, 2025 Leave a message

The production process of the floating body of the floating solar mounting system on the water surface needs to take into account the material performance, structural strength, weather resistance and large-scale production efficiency. The following are the full process steps of a typical float production, taking high-density polyethylene (HDPE) floats as an example:
1. Material preparation
Main material selection:
·HDPE(high-density Polyethylene): It is UV-resistant, corrosion-resistant, and has a low water absorption rate. UV inhibitors (such as carbon black) and antioxidants need to be added.
Reinforcing materials: glass fiber or steel frame (for connection parts that require high strength).
Auxiliary materials: Foaming materials (such as polyurethane foam, used to fill the interior of the floating body to increase buoyancy).
2. Mold design and manufacturing

· Mold type:Blow Molding
It is used for the production of pipe-type floating bodies or small floating cylinders, featuring high efficiency but relatively low strength.

3. Structural reinforcement and assembly
Internal strengthening:
Pre-embed steel frames or fiberglass ribs inside the floating body (to enhance its resistance to wind and waves).
Fill closed-cell foam (such as EPS) to increase buoyancy and.
Anti-sinking property.
Connecting components:
· Pre-embedded stainless steel bolt sleeves or HDPE card slots (for mechanical connection between floating bodies).
Install anti-collision edge guards (made of rubber or HDPE material)
4. Quality Inspection
Sealing performance test
· Air tightness test (fill with 0.2MPa air pressure and hold pressure for 24.
No leakage within hours
· Water tightness test 
· Mechanical property test:

Compressive test (simulating maximum wave load)
Fatigue test (simulating long-term wind and wave cyclic loads) environmental adaptability
·UV aging test (simulating 20 years of sunlight exposure)
Chemical corrosion resistance test (for seawater or freshwater environments).
6. Surface treatment and anti-corrosion
Surface coating
· Anti-slip texture (to prevent maintenance personnel from slipping).
Anti-fouling coating (inhibits the adhesion of algae and shellfish)
· Marking printing: Floating body numbers, safety warnings, etc. (using weather-resistant ink)C
7. Assembly and packaging
Modular assembly
Connect individual floating bodies into an array (such as 6x6 floating body units) through bolts or clips
Pre-installed cable ducts and photovoltaic bracket bases.
Packaging and transportation:
Folding design (reduces transportation volume, such as inflatable ones.)
Floating body.
Standardized loading of containers (anti-collision fixed frames)

Summary
The production of floating bodies needs to balance cost, strength and weather resistance. The core lies in the optimization of material formula and the stability of molding process. For projects with a water depth of 100 meters, it is recommended that the floating body design increase redundant buoyancy (reserving a 30% margin) and strengthen the connection structure to cope with the dynamic loads in deep water.


 

Send Inquiry